Hayward error codes
- CHECK SALT Salt level low (flashing) or too low and shut down (steady)
- INSPECT CELL Cell efficiency reduced or inspection due (flashing); greatly reduced (steady)
- NO FLOW Flow switch sees no water: chlorine generation stopped
- GENERATING (flashing) Water too hot or too cold to make chlorine
- HIGH SALT Salt level too high: generation stopped
- LP Air too cold for the heat pump (not the gas heater's LO)
- LO One of 3 safety switches faulted: water pressure, vent pressure or temperature limit
- IF Ignition failure
- HF Flame present while the gas valve has no power
- AO / AC Blower vacuum switch open (AO) or closed (AC)
- BD / EE Bad control board (BD can also be a secondary high-voltage fault)
- CE Lost communication between control module and display
- HS Return water too hot, or heated too fast
- IO Ignitor circuit open
- PF Low voltage or reversed polarity
- SB Failed keypad
- SF Temperature sensor (thermistor) failed