30 results for “LO”
- LO One of 3 safety switches faulted: water pressure, vent pressure or temperature limit
- CHECK FLOW Not enough water flow to the heater
- NO FLOW Flow switch sees no water: chlorine generation stopped
- Ignition Lockout No pilot sensed, or pilot went out during main-burner trial
- Rollout Sw Open Flame rollout switch open
- Flow Limit (warning) Pump hit the max flow set in Min/Max
- Clock/Fireman Sw Open circuit at the time clock or fireman switch
- Low Temp Lockout Water colder than 36°F
- ERR PS Water pressure switch open: not enough water flowing through the heater
- CHECK SALT Salt level low (flashing) or too low and shut down (steady)
- Water Sw Open Water pressure switch open: not enough flow
- Overheat Drive above 130°F: pump slows down to cool
- Over Current Drive overloaded or motor electrical problem
- ERR AFS Air flow switch open: blower off or its air is restricted
- PF Low voltage or reversed polarity
- Ignition control LED flashes 1 flash air flow, 2 flame without call for heat, 3 lockout, steady control fault
- Power Out Incoming supply voltage too low
- AO / AC Blower vacuum switch open (AO) or closed (AC)
- GENERATING (flashing) Water too hot or too cold to make chlorine
- CE Lost communication between control module and display
- LP Air too cold for the heat pump (not the gas heater's LO)
- Flame w/o CFH Flame sensed with the pilot and main valves ordered shut
- Priming Failure Pump didn't prime within the Max Priming Duration
- INSPECT CELL Cell efficiency reduced or inspection due (flashing); greatly reduced (steady)
- IF Ignition failure
- FAULT- CHECK IGN CONTROL Ignition problem (6 possible causes)
- Internal Error Motor control software error
- Over Voltage Supply voltage too high, or water spinning the pump
- Pressure Limit (warning) Pump hit the max system pressure set in Min/Max
- Speed Limit (warning) Pump hit the max speed set in Min/Max